Troubleshoot Yamaha 2009 Yamaha Raptor 700R Ignition?

Question

I own a 2009 Yamaha Raptor 700r. How do I troubleshoot an ignition system that fails to operate, specifically one that has no spark or intermittent spark?

solved 0
Dave 2 months 2022-12-10T16:18:47+00:00 4 Answers 13 views Beginner 0

Answers ( 4 )

    0
    2022-12-10T16:22:03+00:00

    How to test an ignition system? 

    1. Start by testing the Yamaha Raptor’s battery to ensure it has enough power to supply the ignition system. Use a multimeter to check the battery voltage. It should be around 12.6 volts for a fully charged battery.

    2. Next, check the condition of the spark plugs. Remove the spark plugs and inspect them for any damage or fouling. If they are damaged or fouled, replace them with new ones.

    3. Connect a spark plug tester to the spark plug wires. Crank the engine and observe the spark plug tester for a strong, consistent spark. If the spark is weak or intermittent, it indicates a problem with the ignition system.

    4. Check the condition of the ignition coil. Disconnect the ignition coil and test it using a multimeter. The coil should have a resistance of around 0.7 to 1.3 ohms. If the resistance is outside this range, the ignition coil may be faulty and needs to be replaced.

    5. Finally, test the ignition control module. This component controls the timing and firing of the spark plugs. Use a multimeter to test the module for any shorts or open circuits. If the module is faulty, it will need to be replaced.

    0
    2022-12-10T16:27:02+00:00

    The Yamaha Raptor 700R ignition system is a system that is responsible for igniting the fuel in an internal combustion engine. It is made up of several components, including the spark plugs, the ignition coil, and the ignition control module. When the ignition system is faulty on your Yamaha Raptor 700R, it can cause the engine to not start or to run poorly. In order to fix a faulty ignition system, you will need to diagnose the problem and then replace the faulty component(s). It is best to consult a mechanic if you are not familiar with Yamaha 4-wheeler systems, or download the complete factory service manual at 911manual.com.

    The following troubleshooting procedures are model and year specific to the 2009 Yamaha Raptor 700R YFM70RY. These directions might also apply to 2010 models.

    Testing procedures for 2010 2009 Yamaha Raptor 700

    Continued…

    How do I test ignition on YFM70RY

    What is troubleshooting?

    Troubleshooting is the process of identifying and resolving problems or defects in a system or piece of equipment. This can involve identifying the cause of the issue, implementing solutions to fix the problem, and testing to ensure that the issue has been resolved. Troubleshooting is often used by certified Yamaha mechanics to diagnose and fix issues with engine components and electrical system.

    Best answer
    0
    2022-12-10T16:29:36+00:00

    Where is the cheapest place to buy an ignition system for my Yamaha Raptor?

    0
    2022-12-10T16:33:49+00:00

    In my opinion this is the best place to buy a Yamaha Raptor Ignition System, but you can buy an ignition system from an automotive parts store or a dealership that sells the make and model of your quad. You can also purchase one online from a reputable retailers.

Leave an answer